Underwater Photography Guide Forums
All Things Underwater Photography
Would this be more of a pain as the camera would probably be choosing a slower shutter speed than I would have liked or would this be fine?
In your opinion, would I be better off to shoot full manual instead and forget about sTTL?
Canon G11, Canon OEM housing, Inon S2000 and D4 bracket
- Posts: 34
- Joined: Wed May 12, 2010 4:39 am
Well I like shooting with manual strobe settings all the time. I feel it gives you much more control but you will have to work harder at your photography.
I'm not that familiar with point and shoot set-ups so I'm not sure how your camera / strobe would work in Av mode. Hopefully someone else can answer that.
- Posts: 103
- Joined: Mon May 10, 2010 7:02 am
- Location: Redondo Beach
The beauty of digital of course is that you can try both and know almost instantly what works.
Like Todd, I shoot only manual. Most of the time you will be controlling light with f stop (and the flashes at full power) but you will then start to get creative playing with flash out put and positioning.
Also http://www.uwphotographyguide.com/under ... mera-modes
Don't forget to send some images using both routines.
- Posts: 190
- Joined: Thu May 13, 2010 5:50 am
- Location: Alexandria, Virginia
Now, the sTTL, IMO, based on my use of the sTTL mode now in three different cameras, I think you will have better results in P vs Auto or you can try Av mode.
Shooting in sTTL in Av mode you will want the camera set in the Menu to automatic flash.
JFYI, sTTL selection on the S/D2000 overrides magnet switch position. With the S2000 magnet position is only relevant with the Inon S2000 in the Manual strobe setting.
You can also shoot your G11 with Inon S2000 in Av mode and the Inon S2000 in Manual mode. Set the magnet switch to magnet installed. Set the G11 flash under menu to Manual and then set power to 1/3 or lowest, I forget exactly how it reads in the G11 instruction manual. You can play some tricks like this letting the G11 expose for the background and the strobe for near ground/subject.
Shooting the G11 in Manual mode, set the Inon S2000 to manual and then expose the background via shutter speed selection, use strobe and f stop for near or subject.
JFYI, general note, the S2000 working in sTTL mode will respond to the camera's flash when the camera's flash is operating in Auto. Auto flash is default in A/P and selectable in Av and Tv but factory default is auto until you select it to manual in Menu. So, what does this mean, well, it means you can bias exposure with the strobe by increasing or decreasing flash exposure EV plus or minus two stop under Func Set. Of course, you can also, obviously, alter flash exposure directly with your S2000 using the power knob.
I think I got all of that right, lol .
The OP may already know all this, I am just putting it down for all to pick at.
Canon S90 with FIX90 housing, 2X Inon D2000 strobes, DIY tray, Inon UFL165AD, Inon UCL165AD, Inon UWL100-67 with dome kit, ordered Fisheye UWL-04
- Posts: 139
- Joined: Thu May 13, 2010 7:18 am
Who is online
Users browsing this forum: No registered users and 4 guests