Underwater Photography Guide Forums
All Things Underwater Photography
- Posts: 62
- Joined: Fri May 21, 2010 5:06 am
- Location: Falcon, Western Australia
- Posts: 51
- Joined: Mon May 10, 2010 6:37 pm
remove o rings and place into a lubed ziplock bag. Remove port and close the housing back up. I drop the baggy into the empty housing and cover it with a dust cap. I also place TTl converter inide. I fit two housings, 2 sets of strobes, arms, cords all chargers and ball joints into my stormcase at 49lbs. If im traveling within SE asia the i use 1 housing.
I never travel with camera bodies and housing in one place for fear if they are lost.
Also i am sure to photograph all gear laid out before i pack for insurance reasons. Then i take a photo of mt passport and e-mail it all to my account.
If you lose your gear you must make an accurate police report before leaving the airport.
Damage report as well,
Hope this helps,
- Posts: 17
- Joined: Tue May 11, 2010 4:30 pm
Regardless, after flying you want to remove and re-lube all of your o-rings (strobes, ttl-converter, cables, etc.) since the pressure can affect them.
There's general info on our camera maintenance page, let me know if there is info missing and I'll add it.
- Site Admin
- Posts: 491
- Joined: Sun May 09, 2010 10:31 am
- Location: Marina del rey, CA
Who is online
Users browsing this forum: No registered users and 4 guests